• This UV DTF Wrap is sized for a 16oz Glass Cup (Cup Not Included).
• Printed in-house using Professional Equipment
• Waterproof and scratch resistant
• Hand-wash only
• Do not put it in the dishwasher or microwave
• Cup sizes vary so modification may be required
• You can apply the wrap as a whole, or you can use only parts of it
• No heat is required for the application

**PLEASE READ: We are NOT responsible for transfers damaged during the application process. No refunds, returns, or exchanges will be accepted.

Application Instructions

1. Clean the surface with soap and water

2. Place the cup on a stable surface

3. Measure your cup and trim any excess pieces that may overlap

4. Peel the backing off of the wrap. Make sure all of the pieces lift off while peeling.

5. Make sure the wrap is lined up correctly and began pressing, starting with one side & working around the cup. Remember: These wraps are permanent, once your wrap hits any surface, it WILL stick, pulling up on it may result in your decal breaking.

6. Once you have worked all the way around the cup, go over each part with a squeegee Making sure there are no air bubbles as you go.

7. Remove the clear film carrier sheet. Go slow, the carrier sheet may be hard to remove - just go slow. When peeling, we recommend you peel back laying the film back onto itself rather than pulling it UP while peeling.

We do not sell or claim ownership over the character clipart or characters. They belong to their respective Copyright owners. You are paying for our time collecting, resizing, organizing, processing and printing. All Copyrighted and Trademarked characters belong to their respective Copyright and Trademark.